Industrial Automation
Notes | General: At least one functional insulation against adjacent modules is complied with in the support rail direction. If the application has higher requirements on the insulation (basic or reinforced insulation), then these must be realized through suitable measures (e.g., partition plates). Utilization restriction EMC note: EMC: class A product, see manufacturer's declaration in the download area |
Product properties | Product type: Relay Module Mechanical service life: 1x 107 cycles, approximately |
Electrical properties | Maximum power dissipation for nominal condition: 1.15 W Test voltage (Winding/contact): 2.5 kVrms (50Hz, 1min., winding/contact) Test voltage (Changeover contact/changeover contact): 1 Vrms (50Hz, 1min., changeover contact/changeover contact) Air clearances and creepage distances between the power circuits Rated insulation voltage: 250 VAC |
Input data | Coil side Nominal input voltage UN: 230 VAC Input voltage range: 195.5 VAC ... 253 VAC (20°C) Mains frequency: 50 Hz Drive and function: monostable Drive (polarity): polarized Typical input current at UN: 3.5 mA Typical response time: 4 ms ... 15 ms Typical release time range: 4 ms ... 15 ms Protective circuit: Varistor Status display: Glow lamp |
Output data | Switching Contact switching type: 2 changeover contacts Type of switch contact: Single contact Contact material: AgNi Maximum switching voltage: 250 V AC/DC Minimum switching voltage: 5 V (10mA) Limiting continuous current: 5 A Interrupting rating (ohmic load) max.: 70 W (24VDC) 40 W (48VDC) 35 W (60VDC) 30 W (110VDC) 55 W (220VDC) 750 VA (250VAC) |
Connection data | Connection method: Screw connection |
Dimensions | Width: 22.5 mm Height: 79.4 mm Depth: 60.2 mm |
Environmental and real-life conditions | Ambient conditions Degree of protection (Relay): RT III (Relay) Degree of protection (Installation location): ⥠IP54 (Installation location) Ambient temperature (operation): -20°C ... 50°C Ambient temperature (storage/transport): -40°C ... 85°C Altitude: ⤠2000 m |
Standards and regulations | Standards/regulations: EN50178 EN61810-1 Air clearances and creepage distances between the power circuits Standards/regulations: DINEN50178 |
Mounting | Mounting type: DIN rail mounting Assembly instructions: in rows with zero spacing Mounting position: any |
ECLASS | ECLASS-11.0: 27371601 ECLASS-12.0: 27371601 ECLASS-13.0: 27371601 |
ETIM | ETIM 8.0: EC001437 |
UNSPSC | UNSPSC 21.0: 39122300 |
Description other products