Tecnichal data
Features and Benefits
Rockwell Automation Encompass Approved
PI Certified
Remote diagnostics via Ethernet
Supports DPV1 Acyclic Messaging
Field-tested with multiple PROFIBUS Masters from multiple vendors
AOP provided to allow for seamless integration to Studio 5000 and RSLogix 5000
Video setup tutorial provided on www.prosoft-technology.com
PROFIBUS DP Specifications
DPV1 Class 1 Alarm
DP V1 Class 2 Read/Write/Data Transport
Auto-detection mode is supported
Technical Specs
PROFIBUS DP Specifications
Specification:Description
PROFIBUS DP Cyclic Data:244 Bytes IN / 244 Bytes OUT
Acyclic Read/Writes:240 Bytes
Acyclic communication:DPV1 Class 1 Read/Write
Baud rate:9.6 kBaud, 19.2 kBaud, 45.45 kBaud, 93.75 kBaud, 187.5 kBaud, 500 kBaud 1.5 MBaud, 3 MBaud, 6 MBaud, 12 MBaud
Hardware Specification
Specification:Description
PROFIBUS Interface:RS-485, max. 12 Mbps, potential free, according EN 50170
Diagnostic Interface:10/100 Ethernet, RJ45
Power Supply:+5 V ±5 % / 570 mA
Max. Distance Rating:2 slot
Dimensions:Standard 1769 Single-slot module
Burst:EN 61000-4-4, 2 kV, 5 kHz
Surge:EN 61000-4-5, 2 kV common mode, 1 kV differential mode
ESD:EN 61000-4-2, 4 kV contact, 8 kV air, 4 kV indirect
Radiated/Conducted Immunity:EN 61000-4-3, 10 V/m, 30...1000 MHz, 80% AM, 1 kHz sine wave, EN 61000-4-6, 10 V, 0,15...30 MHz
Radiated/Conducted Emission:EN 55011 Class A
Vibration/Shock:IEC 600068-2-6, 10-150 Hz, ± 0,75 mm, ± 1 g, 1 Octave/min, IEC 600068-2-27, 15 g, 11 ms
Operating Temperature:0°C to 60°C (32°C to 140°F)
Relative Humidity:5 to 95% (non-condensing)
PROFIBUS conformance:Certified
Description
The ILX69 PROFIBUS Slave module is an in-chassis PROFIBUS DPV1 Slave for CompactLogix, supporting cyclic PROFIBUS I/O data and acyclic messaging. Explicit ladder logic CIP message blocks provide slave status diagnostic data and the ability for acyclic messaging.The ILX69 interface appears to the CompactLogix controller as a standard I/O module allowing it to be configured via Studio/RSLogix™5000. The cyclic PROFIBUS I/O data can be configured in Studio/RSLogix™ 5000, or configuration can be transferred from the Master to the slave module. The Ethernet interface allows for remote diagnostic and troubleshooting. Complete program examples for simple and quick start-up are available.
Available 
