2905494 PHOENIX CONTACT - Technology Bsa

PLC-HPT-24DC/220DC/10 - Solid-state relay

PLC-INTERFACE, hybrid solid-state relay incl. bypass relay with push-in connection, for mounting on NS 35/7,5 DIN rail, input: 24 V DC, output: 12 V DC - 250 V DC/10 A

Cod. Articolo: 2905494

Cod. Fornitore: 2905494

PHOENIX CONTACT

Notes	Utilization restriction EMC note: EMC: class A product, see manufacturer's declaration in the download area
Product properties	Product type: Solid-state relay module Product family: PLC-INTERFACE Application: Output function Operating mode: 100% operating factor Insulation characteristics Insulation: safe isolation Insulation characteristics: Air clearances and creepage distances between the power circuits Insulation: safe isolation Overvoltage category: III Pollution degree: 2
Electrical properties	Test voltage: 4 kV_rms (50Hz, 1min., winding/contact) Air clearances and creepage distances between the power circuits Rated insulation voltage: 260 VAC Rated surge voltage: 6 kV
Input data	Rated control circuit supply voltage U_S: 24 VDC Voltage range with reference to U_S: 0.8 ... 1.2 Rated control supply current I_S: Ã¢¤ 19 mA Rated actuating voltage U_C: 24 VDC Voltage range with reference to U_C: 0.8 ... 1.2 Rated actuating current I_C: 6.8 mA "0" signal switching threshold in reference to U_C: < 0.4 "1" signal switching threshold in reference to U_C: > 0.8 Typical response time: 20 ms Typical turn-off time: 40 ms Status display: Yellow LED Protective circuit: Reverse polarity protection Surge protection Surge voltage protection: > 33 VDC Transmission frequency: 1 Hz
Output data	Designation: DC hybrid output Contact switching type: 1 N/O contact Design of digital output: electronic Output voltage range: 12 VDC ... 250 VDC Limiting continuous current: 10 A (see derating curve) Maximum inrush current: 60 A (5ms; T_amb =60°C) Min. load current: 100 mA Surge voltage protection: > 275 V Output circuit: 2-conductor / N/O contact in parallel operation (no electrical disconnection) Protective circuit: Inverse diode (No continuous protection against polarity reversal) Varistor
Connection data	Connection method: Push-in connection Stripping length: 10 mm Conductor cross section rigid: 0.14 mm² ... 2.5 mm² Conductor cross section flexible: 0.14 mm² ... 2.5 mm² 0.2 mm² ... 2.5 mm² (Single ferrule) 2x 0.5 mm² ... 1 mm² (TWIN ferrule) Conductor cross section AWG: 26 ... 14
Dimensions	Width: 14 mm Height: 80 mm Depth: 94 mm
Environmental and real-life conditions	Ambient conditions Degree of protection (Relay base): IP20 (Relay base) Degree of protection (Relay): RT II (Relay) Degree of protection (Installation location): IP54 (Installation location) Ambient temperature (operation): -25°C ... 60°C Ambient temperature (storage/transport): -40°C ... 85°C Altitude: Ã¢¤ 2000 m
Standards and regulations	Air clearances and creepage distances between the power circuits Standards/regulations: IEC 60947-5-1
Mounting	Mounting type: DIN rail mounting Assembly instructions: See derating curve Mounting position: any