2909211 PHOENIX CONTACT - Technology Bsa

REL-OR3/LDP-12DC/3X21 - Single relay

Plug-in octal relays with power contacts, 3 changeover contacts, test button, freewheeling diode, mechanical switch position indicator, polarity A1+, A2-, input voltage: 12VDC

Cod. Articolo: 2909211

Cod. Fornitore: 2909211

PHOENIX CONTACT

Notes	General: The outputs are not suitable for switching different outer conductors. Do not use to separate SELV / PELV circuits from other circuits, because safe isolation is not guaranteed.
Product properties	Product type: Single relay Operating mode: 100% operating factor Mechanical service life: approx. 2x 10⁷ cycles Insulation characteristics Insulation: Basic insulation Insulation characteristicsÃ¢ Insulation: Basic insulation Overvoltage category: III Pollution degree: 3
Electrical properties	Maximum power dissipation for nominal condition: 1.44 W Test voltage (Winding/contact): 2.5 kV_rms (50Hz, 1min., winding/contact) Test voltage (Changeover contact/changeover contact): 2.5 kV_rms (50Hz, 1min., changeover contact/changeover contact) Rated insulation voltage: 250 VAC Rated surge voltage: 4 kV
Input data	Coil side Nominal input voltage U_N: 12 VDC Input voltage range: 10.2 VDC ... 13.2 VDC (see diagram) Drive and function: monostable Drive (polarity): non-polarized Typical input current at U_N: 112 mA Input power dissipation for U_N: 1.35 W Typical response time: 18 ms Typical release time: 20 ms Protective circuit: Freewheeling diode Status display: Yellow LED Coil resistance: 110 Ã© ±10%
Output data	Switching Contact switching type: 3 changeover contacts Type of switch contact: Single contact Contact material: AgNi Maximum switching voltage: 250 VDC 440 VAC Minimum switching voltage: 10 V (At 24 mA) Limiting continuous current: 10 A Maximum inrush current: 30 A (20 ms, N/O contacts) Min. switching current: 10 mA (at 24V) Interrupting rating (ohmic load) max.: 240 W (at 24 V DC) 124 W (at 48 V DC) 108 W (at 60 V DC) 52 W (at 110 V DC) 48 W (at 220 V DC) 2500 VA (for 250 V AC) Motor load according to UL 508: 1/2HP, 240VAC (N/O contact)
Connection data	Connection method: Plug-in connection
Dimensions	Width: 35 mm Height: 35 mm Depth: 54.4 mm
Environmental and real-life conditions	Ambient conditions Degree of protection: RT I Degree of protection (Installation location): Ã¢¥ IP54 (Installation location) Ambient temperature (operation): -40°C ... 70°C Ambient temperature (storage/transport): -40°C ... 85°C Altitude: Ã¢¤ 2000 m
Approvals	Corrosive gas test Identification: ISA-S71.04. G3 Harsh Group EN60068-2-60
Standards and regulations	Standards/regulations: IEC 60664 IEC 61810
Mounting	Mounting position: any