Non disponibile 
| Notes | General: The housing is open on one side. The appropriate cover is D-DEK 1,5 GN (2716949). Use of EB 80-DIK... bridges in the DEK terminal blocks: Absorption of humidity from the ambient air as well as an unfavorable tolerance between a larger number of DEK terminal blocks and the EB 80-DIK... bridge may cause (minor) expansion of the DEK housing. When the EB 80-DIK... bridges are used, therefore, it is recommended that these be disconnected after about 10 to 12 DEK terminal blocks and a wire bridge to the next DEK terminal block be inserted in their place. |
| Product properties | Product type: Solid-state relay module Product family: DEK Application: Filter to prevent interference Operating mode: 100% operating factor Insulation characteristics Insulation: Basic insulation Insulation characteristicsâ Insulation: Basic insulation Overvoltage category: III Pollution degree: 2 |
| Electrical properties | Test voltage (Input/output): 2.5 kV AC (Input/output) |
| Input data | Nominal input voltage UN: 230 VAC Input voltage range in reference to UN: 0.9 ... 1.1 Input voltage range: 207 VAC ... 253 VAC Switching threshold "0" signal, voltage: ⤠92 VAC Switching threshold "1" signal voltage: > 207 VAC Typical input current at UN: 2.5 mA Typical response time: 4.4 ms Typical turn-off time: 14 ms Operating voltage display: Yellow LED Protective circuit: Surge protection; Varistor RC element; RC element Transmission frequency: 5 Hz |
| Output data | Contact switching type: 1 N/O contact Design of digital output: electronic Output voltage range: 3 VDC ... 48 VDC Limiting continuous current: 100 mA Voltage drop at max. limiting continuous current: ⤠0.9 V Output circuit: 3-conductor, ground-referenced Protective circuit: Reverse polarity protection; Polarity protection diode Free running; Freewheeling diode |
| Connection data | Connection method: Screw connection Stripping length: 8 mm Screw thread: M3 Conductor cross section rigid: 0.2 mm² ... 2.5 mm² Conductor cross section flexible: 0.2 mm² ... 2.5 mm² Conductor cross section AWG: 24 ... 14 Tightening torque: 0.5 Nm |
| Dimensions | Width: 6.2 mm Height: 80 mm Depth: 56 mm |
| Environmental and real-life conditions | Ambient conditions Ambient temperature (operation): 0°C ... 50°C Ambient temperature (storage/transport): 0°C ... 70°C |
| Standards and regulations | Standards/regulations: IEC 60947-5-1 |
| Mounting | Mounting type: DIN rail mounting Assembly instructions: in rows with zero spacing Mounting position: any |
| ECLASS | ECLASS-11.0: 27371604 ECLASS-12.0: 27371604 ECLASS-13.0: 27371604 |
| ETIM | ETIM 9.0: EC001504 |
| UNSPSC | UNSPSC 21.0: 39122300 |
Di seguito alcuni articoli correlati a quello che stai vedendo
