2900162 PHOENIX CONTACT - Technology Bsa

FLKM-2KS50/BFI/MKDS/CS - Passive module

Termination board for Yokogawa ADV151, ADV161, ADV551 and ADV561 I/O modules with a fuse for cable protection (5x20) and fuse failure display (LED) per channel. Redundant system connection.

Product Code: 2900162

Partner cod.: 2900162

PHOENIX CONTACT

Product properties	Product type: Interface module No. of channels: 32 Operating mode: 100% operating factor Insulation characteristics Insulation: Functional insulation Insulation characteristicsÃ¢ Insulation: Functional insulation Overvoltage category: II Pollution degree: 2
Electrical properties	No. of channels: 32 Nominal voltage U_N: 24 VDC 19.2 VDC ... 26.4 VDC Max. current carrying capacity per branch: 100 mA (observe derating) Max. total current of all branches: 4 A (observe derating) Rated insulation voltage: 50 VDC Rated surge voltage: 0.5 kV Supported controller YOKOGAWA CS3000 CentumVP Suitable I/O card: ADV151 ADV161 ADV551 ADV561 Supported controller YOKOGAWA STARDOM Suitable I/O card: NFDV151 NFDV161 NFDV551 NFDV561
Output data	Contact switching type: 1 N/O contact Type of switch contact: Double contact Contact material: AgNi, 5 µm hard gold-plated Maximum switching voltage: < 25 VAC 48 VDC Limiting continuous current: 1 A Min. switching current: 1 mA Interrupting rating (ohmic load) max.: 24 W (24VDC) 48 W (48VDC) 25 VA (25VAC) Mechanical service life: approx. 2x 10⁷ cycles
Connection data	Field level Connection method: Screw connection Conductor cross section rigid: 0.2 m² ... 4 mm² Conductor cross section flexible: 0.2 mm² ... 2.5 mm² Conductor cross section AWG: 24 ... 12 Controller level Connection method: Yokogawa KS-compatible Number of connections: 2 Number of positions: 50 Note: Usable system cables: Phoenix Contact YUC50, Yokogawa AKB331 Tightening torque: 0.5 Nm
Signaling	Status display: LED red Status display present: Yes, if the fuse fails Operating voltage display: Green LED
Dimensions	Item dimensions Width: 343.1 mm Height: 111.9 mm Depth: 65.15 mm
Environmental and real-life conditions	Ambient conditions Degree of protection: IP00 Ambient temperature (operation): -20°C ... 65°C Ambient temperature (storage/transport): -20°C ... 70°C Altitude: Ã¢¤ 2000 m
Standards and regulations	Standards/regulations: DINEN50178
Mounting	Mounting type: DIN rail mounting Assembly instructions: in rows with zero spacing Mounting position: any
Notes	General: Voltage monitoring on the module does not work in combination with upstream HESILED fuse terminal blocks with integrated LED display. Do not connect adjacent channels to SELV/ PELV and voltages dangerous to the touch. No additional touch protection is required when using a SELV/PELV voltage (Ã¢¤ 25VAC or 60VDC). Against adjacent modules in the support rail direction at least one functional insulation on the output-side is complied with. If the application has higher requirements on the insulation (basic insulation or reinforced insulation), then these must be realized through suitable measures (e.g. partition plates). For proper use, the specifications of the installation directive (see Downloads) must be observed. For applications or use with third-party products, the specifications, and the safety and warning instructions of the respective third-party manufacturer must also be met.