Industrial Automation
Notes | General: The housing is open on one side. The appropriate cover is D-DEK 1,5 GN (2716949). Use of EB 80-DIK... bridges in the DEK terminal blocks: Absorption of humidity from the ambient air as well as an unfavorable tolerance between a larger number of DEK terminal blocks and the EB 80-DIK... bridge may cause (minor) expansion of the DEK housing. When the EB 80-DIK... bridges are used, therefore, it is recommended that these be disconnected after about 10 to 12 DEK terminal blocks and a wire bridge to the next DEK terminal block be inserted in their place. |
Product properties | Product type: Solid-state relay module Product family: DEK Application: Output function Operating mode: 100% operating factor Insulation characteristics Insulation: Basic insulation Insulation characteristics: Standards/regulations Insulation: Basic insulation Overvoltage category: II Pollution degree: 2 |
Electrical properties | Maximum power dissipation for nominal condition: 0.5 W Test voltage (Input/output): 2.5 kV AC (Input/output) |
Input data | Nominal input voltage UN: 24 VDC Input voltage range in reference to UN: 0.8 ... 1.2 Input voltage range: 19.2 VDC ... 28.8 VDC Switching threshold "0" signal in reference to UN: ⤠0.4 Switching threshold "1" signal in reference to UN: ⥠0.8 Typical input current at UN: 3.5 mA Typical response time: 250 µs Typical turn-off time: 800 µs Operating voltage display: Yellow LED Protective circuit: Reverse polarity protection Surge protection Transmission frequency: 100 Hz |
Output data | Contact switching type: 1 N/O contact Design of digital output: electronic Output voltage range: 5 VDC ... 30 VDC Limiting continuous current: 10 A (see derating curve) Surge current: 100 A (t=20ms) Voltage drop at max. limiting continuous current: ⤠50 mV Output circuit: 3-conductor, ground-referenced Protective circuit: Reverse polarity protection Surge protection |
Connection data | Connection method: Screw connection Stripping length: 8 mm Screw thread: M3 Conductor cross section rigid: 0.2 mm² ... 2.5 mm² Conductor cross section flexible: 0.2 mm² ... 2.5 mm² Conductor cross section AWG: 24 ... 14 Tightening torque: 0.5 Nm |
Dimensions | Width: 6.2 mm Height: 80 mm Depth: 56 mm |
Environmental and real-life conditions | Ambient conditions Ambient temperature (operation): -20°C ... 60°C Ambient temperature (storage/transport): -20°C ... 70°C |
Standards and regulations | Standards/regulations Standards/regulations: IEC 60947-5-1 |
Mounting | Mounting type: DIN rail mounting Assembly instructions: in rows with zero spacing Mounting position: any |
ECLASS | ECLASS-11.0: 27371604 ECLASS-12.0: 27371604 ECLASS-13.0: 27371604 |
ETIM | ETIM 9.0: EC001504 |
UNSPSC | UNSPSC 21.0: 39122300 |
Description other products