WRC-CANR-DF-DN PROSOFT TECHNOLOGY

Key Features
Expands the usable applications for DeviceNet, J1939, SDS, and other CAN V2.0, Part A and Part B compatible CAN bus systems
Enables the creation of star, tree and other non-linear network topologies which increases flexibility in system design and reduces installation costs
Works with both trunk lines and drop lines
Allows operation at higher speeds for specific distances
Fiber-optics provide superior electrical interference protection versus copper cables
Operates at 9.6K to 1M fixed baud for J1939 or CAN bus networks
Auto-detects baud rate on DeviceNet (125k, 250k, or 500k baud)
Isolates the two sections of the CAN bus (copper wire)
Extender operation is transparent to Master and Slave devices
Powered from the CAN bus network
Sealed NEMA-4X enclosure
Standard round, mini-style connector with male pins for copper cable
Standard Fiber Optic ST female connector for use with multi-mode fiber
Standard CAN chips manage CAN bus error detection and handle message bus arbitration
Less than 900 µsec latency
Termination resistor built in on the CAN bus interfaces
Two identical WRC-CANR-DF units are included in an order kit and both are required for each application
Series IV CANR Enhancements include
Up to 12km fiber lengths
CAN 2A, CAN 2B, and remote frame support
Expanded DIP switch settings allow selection for CAN bus speeds up to 1M baud
Enhanced autobaud operation
Either unit in a pair can Autobaud from the other units defined baud rate
Improved Reverse voltage protection and CAN line noise immunity
Increased message internal buffers Ã¢ Automatic Memory Technology (AMT) operation
Eliminates the distinction between WRCÃ¢s earlier version Type 1 and Type 2 CANR